Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| en:hardware:homelab:controller:xmega128 [2015/03/13 17:31] – heikopikner | en:hardware:homelab:controller:xmega128 [2020/07/20 12:00] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ~~PB~~ | + | < |
| ====== Controller module ATxmega128A1U v1.x ====== | ====== Controller module ATxmega128A1U v1.x ====== | ||
| - | |||
| - | < | ||
| The main module of the HomeLab is a controller development board (controller board) equipped with a new generation of Atmel ATxmega128A1U USB-enabled microcontroller. In addition to the microcontroller, | The main module of the HomeLab is a controller development board (controller board) equipped with a new generation of Atmel ATxmega128A1U USB-enabled microcontroller. In addition to the microcontroller, | ||
| Line 71: | Line 69: | ||
| |26|VCC|- |+3.3V | | |26|VCC|- |+3.3V | | ||
| - | ~~PB~~ | + | < |
| {{: | {{: | ||
| Line 136: | Line 134: | ||
| */ | */ | ||
| - | ===== Ühendamine | + | ===== Connecting |
| - | Kontrollermooduli ühendamisel teiste moodulite ning seadmetega tuleb esmalt veenduda, et Kontrollermooduli toide ei ole ühendatud. Ajal kui moodul on pingestatud, on ohtlik seadmeid ühendada. Mooduleid ja seadmeid tuleb omavahel ühendada ettevaatlikult ja liigset jõudu kasutamata. Vale käsitlemise korral võivad piikriba piigid kergesti kõveraks painduda. Programmeerimiseks ja nõrkvoolu | + | When connecting the controller module with other modules or devices, you must first make sure that the controller module power supply is not connected. Modules and devices must be connected to each other with care. It is important not to use excessive force, wrong handling may damage the module. For programming and to power with low currency |
